Use this page to flash the latest firmware to your DL2CC REMOTE-CW-BOX.
Please note that as the firmware is copyright protected it will store license information in the device. You will never be able to use it for another purpose.
Be careful: the firmware will only run if a valid license is acquired!
If you flash a wrong device, it might be permanently locked and not be usable.
The author doesn't guarantee an error free solution. Due to unforseeable circumstances, the disruption of the project including the possible loss of functionality of the device or the accompanying software applications is possible. The author is not liable for any damage to the device or the accompanying software applications nor to any damage resulting from the usage of the device nor from installing and using the accompanying software applications.
Please note that once the device is flashed, you will never be able to use it for another purpose as the firmware source will be bound to this project and the license information is stored in the device. It will be possible to update the firmware with future releases of the project, but you will never be able to use it for another purpose.
Flashing will take over a minute. Check the progress bar - if it proceeds and after flashing the device reboots and announces HI you're all set. A standard popup error device busy will be normal. If there is no window and just "Connecting" is displayed, it's OK too.
After that, close this window, disconnect USB cable from PC and plug it in again after a few seconds. Device will reboot again.
Then start up your DL2CC-Remote-CW Tools (CW1) - port should be auto detected - if not, set the COM Port in Settings, then go to Hardware to set parameters.